3 Major Reasons Why Your Heater Is Blowing Cold Air

3 Major Reasons Why Your Heater Is Blowing Cold Air

There are different types of heaters, but many people use central air to heat their houses, and the place should be warm after the heating system has been running for a while. It can take anyplace from half an hour to one hour to warm the temperature to a subtle level, depending on the size of your home.

It’s not unexpected if you turn on the heat and see frigid air flowing out of the vents, especially if the system has been off for some time. Only be worried if the system continues to blow cold air after a few minutes since this suggests a problem.

Many individuals may experience chilly air from their heating system, which may be caused by several issues that can only be identified by evaluating the design and thermostat. If you don’t want to go through all troubleshooting methods, contact a furnace repair in Woods Cross, UT HVAC specialist by searching heating repair near you on the internet to determine why your heater’s air is so cold.

Dirty Air Filters May Reduce Heat Output

Air filters are essential to catch dust, filth, and particles in the air that would otherwise be blown from room if the heating system did not have one. The essential thing to remember about air filters is that they must be updated regularly, generally every three months, unless the heater is not used often.

Changing the air filter could assist with the cold air problem, but only if it’s the only thing keeping the furnace from spewing hot air instead of cold.

On a Gas Furnace Check the Pilot Light

In a gas furnace, an outed pilot light is a common problem that causes frigid air to shoot out the vents instead of heat. The stove’s pilot light should be on if the furnace’s gas is lit to offer the household warmth. But, first, check the pilot light to see whether it’s turned on; if it isn’t, it might be the reason why the furnace isn’t blowing warm air.

Check the Settings and Batteries in Your Thermostat.

The thermostat controls any heating source in a home with central air, whether it’s a furnace or an HVAC system. There might be various problems with the thermostat causing it to blow cold air instead of warm air.

It’s also worth mentioning that if a battery only powers the thermostat, the battery may be too low to adequately operate it, resulting in you not receiving the desired heat when you turn on the heating element. The thermostat has a battery within, even though it is powered by electricity. As required, replace it. Also, make sure the thermostat’s fan setting is set to “auto” rather than “on,” since “on” will only run the fan without heat, resulting in frigid air rather than warm air coming through the vents.

Whether you have a HVAC unit, if you’ve tried troubleshooting and still can’t figure out why cool air continues blowing in your home, you’ll need the help of a Stanton area specialist. First, contact a Furnace repair Woods Cross, UT HVAC specialist by searching furnace installation near you on the internet. Then, visit the official website of BLR Heating and Air 385-220-8171.